The Perovskite-Info newsletter (November 1, 2022)

Researchers from China's Huazhong University of Science and Technology and Singapore's National University of Singapore have introduced an eco-friendly and low-cost organic polymer, cellulose acetate butyrate (CAB), to the grain boundaries and surfaces of perovskites, resulting in a high-quality and low-defect perovskite film with a nearly tenfold improvement in carrier lifetime.

The CAB-treated perovskite films have a well-matched energy level with the charge transport layers, thus suppressing carrier nonradiative recombination and carrier accumulation. As a result, the optimized CAB-based device achieved a champion efficiency of 21.5% compared to the control device (18.2%).

Chinese perovskite solar technology company Renshine Solar (Suzhou) has announced achieving steady-state efficiency of 24.50% for all-perovskite tandem cell module, which it called 'a world record'.

It was reported that the efficiency was achieved for a perovskite module with an area of 20.25 cm², which exceeds that of perovskite single-junction components. The new efficiency level has been certified by Japan’s JET, it added without sharing other details.

Scientists from the Ural Federal University (UrFU) and the Institute of Organic Synthesis of the Ural Branch of the Russian Academy of Sciences (along with their colleagues) have proposed a new type of material for transporting electrons in perovskite solar cells, which has a number of advantages.

The team reported that with the new material, they were able to achieve solar energy conversion efficiency of 12%. "The family of molecules we found carries electrons in PSCs slightly worse than the fullerenes used today, but they are about twice as cheap, much easier to produce, and have a number of other technological advantages," says Gennady Rusinov, associate professor at the Department of Organic Synthesis Technology of UrFU.

Researchers from the Ulsan National Institute of Science and Technology (UNIST) have teamed up with researchers from Daegu Gyeongbuk Institute of Science and Technology (DGIST) to develop a patterning technique for the production of perovskite nanocrystal displays which are ultra-thin and high-resolution. The production involves a very simple stamp-like printing process that will facilitate the commercialization of the new technique.

Double-layer transfer printing process with RGB pixelated arrays of PeNCs. Image from Science Advances

The technique reportedly enabled the team to produce a display with RGB pixel patterns of 2,550 pixels per inch, which is about 400 percent higher resolution than the latest high-end smartphones.